ProBox23 MS-B083 G52-B0831X1
Memory The SO-DIMM slot is intended for memory modules. 1. Locate the SO-DIMM slot. Align the notch on the memory with the key on the slot and inse
Wireless LAN Card and Antenna Important The wireless LAN card has only one notch and will only fit in the right direction. Step 1. Rolling off the s
mSATA Card Important The mSATA card has only one notch and will only fit in the right direction. Step 1. Rolling off the screw on the fixing bolt.
Hard Disk Drive (HDD) Step 1. Locate the HDD holder. Step 2. Take out and press the four plastic spacers from the bigger hole on the holder to the
Step 5. Arrange the cables. Place the HDD holder with HDD drive to the case and fix the three screws. Step 6. Place the cover back and fix the four
Getting Started How to Use this Service Manual This Service Manual is targeted for MSI-authorized dealer or service center. It provides in-depth ill
Safety Precautions The following precautions should be observed while handling the system: Place the system on a flat and stable surface.
System Assembly Cover & HDD Holder Important Before you remove or install any components, make sure the system is not turned on or connected to
Then you can see the internal of the system. For installing CPU/ Memory module/ WIFI module/ M-SATA module, you also need to remove the HDD holder.
CPU & Heatsink When installing a CPU, always remember to install a CPU heatsink. A CPU heatsink is necessary to prevent overheating and maintain
3. Align the notches with the socket alignment keys. Lower the CPU straight down, without tilting or sliding the CPU in the socket. Inspect the CPU
6. Evenly spread a thin layer of thermal paste (or thermal tape) on the top of the CPU. This will help in heat dissipation and prevent CPU overheati
11. Finally, attach the CPU fan cable to the CPU fan connector on the motherboard. Important Confirm that the CPU heatsink has formed a tight sea
Komentarze do niniejszej Instrukcji